2018-2019 Catalog and Student Handbook 
    
    Mar 28, 2024  
2018-2019 Catalog and Student Handbook [ARCHIVED CATALOG]

Pre-Industrial Technology (A.S. Degree)


General Education Requirements


Note: All courses must be from the Approved Courses for General Education  courses for each category listed in the General Education section of this catalog. Additional courses may be required to overcome deficiencies in English, mathematics, and reading.

Learning Support


Additional courses may be required to overcome deficiencies in English, mathematics, and reading.

Fall


Spring


Total Credit Hours: 62


* Students who are not prepared for MATH 1710 will also need MATH 1100  based on placement testing.

Additional Recommended Courses


The program outlined above meets minimum graduation requirements for Northeast State. However, some or all of the following courses are also required by most engineering programs at the four-year level and in some articulation agreements. The student should consult the catalog of his/her intended transfer institution and see an advisor to formulate an optimal program of study.

Transfer Requirements


The university parallel Associate of Science degree program with emphasis in Industrial Technology is designed for transfer to Tennessee Technological University and may be accepted by other regional colleges and universities which offer a bachelor’s degree program in Industrial Technology. The program of study may be altered to fit the degree requirements at a particular transfer institution. A faculty advisor in the pre-engineering program can assist with appropriate course selection.

For Further Information


Malissa Trent
Dean, Mathematics
Telephone: 423.354.2521
mbtrent@NortheastState.edu