General Education Requirements

Note: All courses must be from the  Approved Courses for General Education  courses for each category listed in the General Education section of this catalog. Additional courses may be required to overcome deficiencies in English, mathematics, and reading.

Fall

• Behavioral/Social Science - Select one approved course Credits: 3
• EDUC 1030 - ♦College and Lifelong Learning Credits: 3
• ENGL 1010 - ♦Composition I Credits: 3
• Humanities and/or Fine Arts - Select one approved course Credits: 3
• MATH 1910 - ♦Calculus I Credits: 4 *

Spring

• CHEM 1110 - ♦General Chemistry I Credits: 4
• ENGL 1020 - ♦Composition II Credits: 3
• Humanities and/or Fine Arts - Select one approved course Credits: 3
• MATH 1920 - ♦Calculus II Credits: 4
• Speech - Select one approved course Credits: 3

Fall

• ENGR 2110 - ♦Engineering Statics Credits: 3
• History - Select one approved course Credits: 3
• Literature - Select one approved course Credits: 3
• MATH 2010 - ♦Linear Algebra Credits: 3

• or

• MATH 2050 - Calculus Based Probability and Statistics Credits: 3 **
• MATH 2110 - ♦Calculus III Credits: 4
• PHYS 2110 - ♦Calculus-Based Physics I Credits: 4

Spring

• Behavioral/Social Science - Select one approved course Credits: 3
• ENGR 2330 - ♦Engineering Dynamics Credits: 3
• History - Select one approved course Credits: 3
• MATH 2120 - ♦Differential Equations Credits: 3
• PHYS 2120 - ♦Calculus-Based Physics II Credits: 4

Total Credit Hours: 69

Additional Information

* Students who are not prepared for calculus will also need some or all of the following courses based on placement testing: MATH 1100, MATH 1710, MATH 1720.

** UT Knoxville accepts Northeast State’s MATH 2080 as an equivalent course for STAT 201 - Introduction to Statistics.

Students are strongly encouraged to complete a course in Mechanics of Materials, also known as Strength of Materials, before transferring to a university.

Courses in engineering technology do not fulfill any of the requirements for the Area of Emphasis in Mechanical Engineering.

Although it is possible to complete the B.S. Degree in Mechanical Engineering in four semesters after earning the associates degree, students typically need five or six semesters to complete requirements.

Students interested in Pre-Engineering: Industrial and Systems should follow the Tennessee Transfer Pathway for Pre-Engineering: Mechanical.

Transfer Requirements

Tennessee Transfer Path to UT/TBR four year universities in compliance with Complete College Tennessee Act of 2010.

For Further Information

Malissa Trent
Dean, Mathematics
Telephone: 423.354.2521
mbtrent@NortheastState.edu