|
|
Dec 05, 2024
|
|
2022-2023 Catalog [ARCHIVED CATALOG]
Pre-Industrial Technology (A.S. Degree)
|
|
|
General Education Requirements
Note: All courses must be from the Approved Courses for General Education courses for each category listed in the General Education section of this catalog. Additional courses may be required to overcome deficiencies in English, mathematics, and reading. Learning Support
Additional courses may be required to overcome deficiencies in English, mathematics, and reading.
Additional Information
*Students who are not prepared for MATH 1710 will also need MATH 1100 based on placement testing.
**Students who are not prepared for CHEM 1110 will need some or all of the following based on placement test scores: MATH 1100 and/or MATH 1710 or concurrent enrollment in CHEM 1000 .
***Students who are not prepared for PHYS 2010 will need some or all of the following based on placement test scores: CHEM 1000, MATH 1100, or MATH 1710.
The program outlined above meets minimum graduation requirements for Northeast State. However, some or all of the following courses are also required by most engineering programs at the four-year level and in some articulation agreements. The student should consult the catalog of his/her intended transfer institution and see an advisor to formulate an optimal program of study.
Transfer Requirements
The university parallel Associate of Science degree program with emphasis in Industrial Technology is designed for transfer to Tennessee Technological University and may be accepted by other regional colleges and universities which offer a bachelor’s degree program in Industrial Technology. The program of study may be altered to fit the degree requirements at a particular transfer institution. A faculty advisor in the pre-engineering program can assist with appropriate course selection. |
|
|
|
Connect with Northeast State