Construction Electricity

The Construction Electricity certificate program prepares individuals for employment in areas of residential, industrial, and commercial wiring. The program emphasizes wiring procedures and requirements set forth by the National Electrical Code. Emphasis is placed on the installation of service equipment, electrical circuits, conduit bending, and the installation and operation of motors.

All courses taken in the Construction Electricity certificate program will articulate into the Associate of Applied Science degree program in Electrical Technology - Concentration: Electrical.

General Education Requirements

Note: All courses must be from the Approved Courses for General Education courses for each category listed in the General Education section of this catalog.

Learning Support

Students must complete learning support deficiencies in reading and MATH 0801, or have appropriate entrance scores.

Fall

EDUC 1030 - ♦College and Lifelong Learning Credits: 3
ELEC 1110 - DC Fundamentals Credits: 4
ELEC 1210 - National Electric Code Interpretations I Credits: 4

Spring

ELEC 1120 - AC Fundamentals Credits: 4
ELEC 1310 - Motors, Alternators, and Generators Credits: 4
ELEC 2310 - National Electric Code Interpretations II Credits: 4

Total Credit Hours: 23

Gainful Employment Disclosure

As required by the U.S. Department of Education
http://apps.northeaststate.edu/GainfulEmployment/

For Further Information

Fred Cope
Associate Professor, Electrical Technology
Telephone: 423.354.2442
fmcope@NortheastState.edu

Steve Smith
Instructor, Electrical Technology
Telephone: 423.354.2410
srsmith@NortheastState.edu

Click here to contact the Technologies division.

Contact

Address

New Students

Current Students